removing cv joint from the driveshaft

Started by cc, September 14, 2019, 10:48:23 AM

Previous topic - Next topic

cc

Hi
Have removed the circlip from the end of the drive shaft but the axle wont tap out of the cv joint..
suggestions?

bonno

#1
Holding CV centrally in vice, try tapping the outer casting equally, ie; first  tap and  second tap 180 degree opposite side etc (bit of wd40 around spline area should also help). 

Citroƫnbender

Tap the outer back onto its seat/shoulder. Wipe the circlip groove clean and inspect for burring - remedy as needed.

Use copper faced hammer to smack the central shaft through, finish with brass or copper drift once it's flush.