156 2.0 JTS rigid coolant pipe leak

Started by 156and33, September 17, 2017, 08:21:42 AM

Previous topic - Next topic

156and33

Hello

I have had two goes at fitting a new front rigid coolant pipe on my JTS and am not getting it to seal. The pipe is new and the seal is not damaged. I have cleaned the head and removed all the crusty residue built up from the previous leak. There is some minor discolouration of the mating surface which appears to be corrosion. My second attempt yesterday used a small amount of aviation sealant on the o-ring to try and fill any defects in the mating surface. I have not torqued the bolts just snugged up firmly. Still leaks.

Feeling knackered from replacing the alternator as well yesterday. Would really like a foolproof (yes, I must be a fool to keep this car) solution for the next go.

How about removing the silicone seal and using RTV to form a gasket in place?

Thanks

bonno

Hi 156and33
Are you referring to the Air Conditioner rigid pipes, rather than the coolant tank rubber hoses. If A/C pipes you will need to take it to A/C specialist to replace/repair, evacuate and regas.
Regards
bonno 

156and33


bonno

In that case, the mating surface need to be absolutely clean and without imperfections for it to effectively seal.

Citroƫnbender

Is it possible the bolts bottom out before sufficiently compressing the joint?

Does it only weep under hot pressure?

156and33

Hey, that is a posbility I had not thought about and it could well be the problem  they could have water in them. Thanks

Mick A

There is a metal bracket for the heat exchanger piping to the oil filter housing. This must sit over the plastic manifold mount where they both sit on a stud and are secured with a 13mm nut.

If you have it the other way around, the plastic manifold will not sit flush against the sealing surface on the head. It will appear flush, but it will never seal properly due to the slight angle.

Cheers.

Mick.

156and33

Not really sure what you are describing on this vehicle.  Will check next weekend when I try and fix it again.

156and33

Success!
Thanks Mick A, I did have the oil cooler pipe bracket on the wrong side of the rigid coolant pipe.  Also, blew out all the bolt holes for good measure. Nothing leaking on garage floor after drive and sitting for 5 hrs. If OK in morning I will replace underbody tray.  So car should be good to go with new cam cover gasket, coolant pipe and alternator.

Thanks everyone.

tidimel

Good afternoon for every one.

I've got the same problem as author of this topic.
I've read this, but i don't know wich metal bracket you mean guys.

Can i ask for a photo of proper mounting of this plastic water coolant pipe?
I bought new one, installed it over 6 months ago and now, when it's hot outside, when i turn off engine and it's cooling down i see water coolant drops going down from the left side of this pipe (staying in fron of it).
Sorry for my eng.

Rgrds Mat.

bonno

Hi Mat
Refer to Mick A post above regarding bracket and also did you replace the gasket #7 as well when new coolant pipe fitted. For your reference I have attached photo of IPB of the cooling system.

tidimel

Bonno, of course plastic pipe was changed with new one gasket.
I didn't do it by myself, my mechanic did that;)

Yesterday I checked the fixing screws from the gasket side.
I think I have to buy a new one gasket, reserve a few hours, dissemble this plastic pipe and perfectly clean the connection between engine and gasket. If it doesn't help, I'll buy big pack of water coolant and put in in the trunk...

I see that is a common problem with this engine. In 1.8 Twin Spark there was an metal pipe, not plastic.

Thanks for picture.